How to maintain and maintain the high speed mixer

When using a high-speed mixer, you must follow the correct steps to operate it. If you do not pay attention during the operation, it is easy to cause problems. Therefore, users should pay special attention when using a high-speed mixer, because long-term use of high-speed mixers The mixing opportunity has an impact on its service life. In order to prolong its service life, it is necessary to regularly maintain the high-speed mixer. Below we teach you how to maintain and maintain the high-speed mixer. Maintenance of the high-speed mixer: ①It should be performed according to the operating procedures of the equipment, which is a better protection and maintenance for the equipment. ② Note that after the equipment starts normally, add the materials and mix, and the materials should be added slowly in the required order. ③ Prepare the sealing ring, the rubber ring for the coupling, the V-belt and the rolling bearing. The working parts of these parts are prone to failure and need to be replaced in time. ④Regularly In the first quarter, check whether the fasteners are loose; check the tightness of the V-belt device; all parts of the equipment should be cleaned and dusted. Maintenance points of high-speed mixer: ①Check and trim the mixing paddle, scraper and the clearance of the mixing chamber wall should meet the requirements of the following table. ② Disassemble each rolling bearing, clean and inspect it; replace the severely worn parts. Replace grease and seals. ③ Check whether the main drive shaft is bent or worn. ④ Check and clean the cylinder, replace the consumable parts of the sealing ring and guide sleeve, and check whether the piston rod is bent, deformed and worn. ⑤ Make a record after the inspection of the parts, inspect when necessary, prepare the parts and accessories, and propose the next repair and replacement. In fact, when maintaining the high-speed mixer, you need to pay attention to the steps. Follow the steps to operate step by step. I believe that the problem can be solved very well. Of course, if there is a problem in any step and you don’t know how to deal with it, you can contact us for consultation. When maintaining the high-speed mixer, it needs to be operated regularly. Don't operate it when you remember it. If it is not maintained regularly, it will be prone to problems in the future.