Reasons for shaft breakage of R/S/K/F hardened reducer

In many mechanical equipment, the use of reducers is very necessary. Nowadays, among many reducers, several R/S/K/F hardened reducers are widely used. I believe that many people have a distress, that is, in the process of using the R/S/K/F hard tooth surface reducer, there will be broken shafts, so how should we solve this situation? Let's take a look How to deal with broken shaft of R/S/K/F hardened reducer. Reasons for shaft breakage of R/S/K/F hardened reducer The external main reasons for the broken shaft should include the following aspects: the bearing capacity of the reducer of the selected belt conveyor is not enough, that is, the drive reducer of the belt conveyor is selected too small, when the actual power of the reducer exceeds the bearing capacity of the reducer After the capacity, the shaft of the belt drive reducer will be broken in the corresponding time; the hydraulic coupling and the brake wheel are usually installed between the motor shaft and the reducer shaft. When the dynamic balance of the brake wheel and the hydraulic coupling is not good, Serious eccentricity will cause great vibration when the belt conveyor is running. When the vibration load reaches a certain level, the stress on the output shaft of the reducer is too large and it breaks; the deviation of the concentricity of the installation is too large. If the concentricity between the reducer and the motor shaft should be carefully adjusted when installing the hydraulic coupling and the brake wheel between the motor and the reducer, if the deviation is too large, the coupling and the brake wheel will run When there is too much vibration, the shaft breaks. In the above article, the editor introduced the reasons for the broken shaft of the R/S/K/F hardened gear reducer. If we want to avoid the appearance of broken shaft, we can do it from these aspects. Maintenance of R/S/K/F hardened gear reducer to reduce the impact of use caused by broken shaft. I hope this article can help you all. The R/S/K/F hard tooth surface reducer brand produced by our company has a good response in the market, you can understand it.